Allied Telesis AT-S63 - Manual (Page 418)

Chapter 22: Spanning Tree and Rapid Spanning Tree Protocols
418 Section V: Spanning Tree Protocols
Configuring STP
This section contains the following procedures:
 ”Configuring STP Bridge Settings”, next
 “Configuring STP Port Settings” on page 421
 “Displaying STP Port Settings” on page 424
 “Resetting STP to the Default Settings” on page 425
Configuring STP
Bridge Settings
This section contains the procedure for configuring a bridge’s STP
settings.
Caution
The default STP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how STP works might have a negative effect on your network. You
should consult the IEEE 802.1d standard before changing any of the
STP parameters.
To configure the bridge settings, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 151 on
page 416.