Lenze PLC Designer R3-x - Manual (Page 121)

Lenze · Commissioning of Lenze drives · 1.3 EN - 06/2014
121
The L_LCB_LogicControlBasic library
L_LCB_ActuatorSpeed
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Outputs
xDriveSetQSP
BOOL
TRUE: Activate quick stop
xResetError
BOOL
TRUE: Reset error message (acknowledged)
xEnableSpeedSetpoint
BOOL
TRUE: Speed control activated
• The inputs xJogSet1, xJogSet2 and rSpeedSetPoint are evaluated.
xJog1Set
BOOL
TRUE: Jog 1 activated
• Speed setpoint 1 requested
• Active if xEnableSpeedSetpoint = TRUE
xJog2Set
BOOL
TRUE: Jog 2 activated
• Speed setpoint 2 requested
• Active if xEnableSpeedSetpoint = TRUE
xInvertDirectionSet
BOOL
TRUE: Inversion of the direction of rotation of the motor (clockwise rotation/
counter-clockwise rotation)
rSpeedSetpoint
REAL
Setpoint selection for the speed in [%]
• Active if...
• xEnableSpeedSetpoint = TRUE and xJog1Set = FALSE and xJog2Set = FALSE
Identifier/data type Information/possible settings
xError
BOOL
"Error" status signal
FALSE Conversion carried out without errors
TRUE Error during the conversion
eError
L_LCB_Error
Error number, error code
xCommunicationOk
BOOL
Status of bus communication
FALSE No bus communication active
TRUE Bus communication available
xInternalControlActive
BOOL
TRUE: The output signals that the xEnableInternalControl input and the Internal
Control button of the visualisation have been activated.
• The control via visualisation is activated.
xDriveError
BOOL
Status signal "Error in controller"
xDriveWarning
BOOL
TRUE: Controller is in "Warning" device state
xDriveReady
BOOL
Status signal "Controller is ready for operation"
xDriveEnabled
BOOL
TRUE: Controller has been enabled
xDriveQSPActive
BOOL
TRUE: Quick stop active
xSpeedEqZero
BOOL
TRUE: Speed is zero
xDirectionCCW
BOOL
Display of the direction of rotation of the motor
TRUE:CCW rotation is active
xHW_Input1
BOOL
Digital input 1 is active
xHW_Input2
BOOL
Digital input 2 is active
Identifier/data type Information/possible settings