Lenze PLC Designer R3-x - Manual (Page 55)

Lenze · Commissioning of Lenze drives · 1.3 EN - 06/2014
55
Extending sample projects - adding devices
Create control configuration - bus system CAN
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2. Use the CANbus tab to set the baud rate.
3. Use the Add Device command to extend the control configuration by "CANopen
Manager".

Note!
The baud rate set in the »PLC Designer« overwrites the baud rate set for the field devices
via »WebConfig«/»Engineer«.
In a CANopen network, set the same baud rate for all nodes.