Lenze PLC Designer R3-x - Manual (Page 34)

Working with the sample projects
Sample project with the "Actuator speed" application - Actuator Speed
34
Lenze · Commissioning of Lenze drives · 1.3 EN - 06/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.1.6.2 Automatic mode
• Button  selects the automatic mode.
• Button  starts the motion profile.
• Button  inhibits the motion profile.
• Display field  indicates the status of the mode.
• Display field  shows the current speed (Speed Value variable).
• Dialog box indicates the machine status.
• Control field  shows the bus communication status.
• Control field Error indicates the error message status.
• Error in the application
• Error in the controller
• The Error Reset button resets the error messages.
7.1.6.3 Manual mode ("Manual jog")
The controller can be actuated manually via the visualisation of the L_LCB_ActuatorSpeed block.
 Select mode  Stop button  Actual speed Status
Start button  Status  Status

Note!
If a bus communication error occurs, the control and drive controller are to be restarted,
since the sample application does not support an automatic reset of bus
communication.