Feature select group (cont.) – Rockwell Automation 1305 AC Drive, Series A and B, Firmware 4.xx-5.xx User Manual
Page 107
Advertising
Chapter 5 – Programming
5-35
Feature Select Group (cont.)
[Balance Freq]
(FRN 4.01 and below only)
Parameter # 80
Factory Default 0 Hz
[Balance Freq]
(FRN 4.01 and below only)
Parameter Type Read & Write
Minimum 0 Hz
This parameter selects the frequency at which balance
detection is performed.
Units 1 Hertz
Maximum 255 Hz
[Balance Time]
(FRN 4.01 and below only)
Parameter # 79
Factory Default 0 Sec
[Balance Time]
(FRN 4.01 and below only)
Parameter Type Read & Write
Minimum 0 Sec
This parameter determines the amount of delay time
before a valid output occurs. The delay time begins when
the drive reaches [Balance Freq]. The output contact will
be closed when balanced and open when unbalanced.
Units 0.1 second
Maximum 255 Sec
Advertising