Rockwell Automation 1305 AC Drive, Series A and B, Firmware 4.xx-5.xx - Manual (Page 118)

Chapter 5 – Programming
5-46
Diagnostics Group (cont.)
[Power Mode] Parameter # 44
Parameter Type Read Only
This parameter is used for internal diagnostic purposes.
[Drive Type] Parameter # 61 [Drive Type]
Parameter Type Read Only
This parameter displays a decimal number that identifies
the drive. Units None
[Drive Firmware] Parameter # 71 Factory Default None [Drive Firmware]
Parameter Type Read Only Display 0.00
This parameter displays the version number of the drive
firmware.
[Output Pulses] Parameter # 67 Factory Default None [Output Pulses]
Parameter Type Read Only Minimum 0
This parameter displays the number of output cycles for
the PWM waveform. The count rolls over at 65535. Units Cycles Maximum 65535
[Drive Temp] Parameter # 70 Factory Default None [Drive Temp]
Parameter Type Read Only Minimum 0 _C
This parameter displays the internal drive temperature. Units 1 _C Maximum 100 _C
[Set Defaults] Parameter # 64 Factory Default ‘‘Ready” [Set Defaults]
Parameter Type Read & Write
Setting parameter to ‘‘Default Init” resets all parameters to
e r r v ues See s p e M M de
Units None Settings ‘‘Ready” Display After Function Complete Setting parameter to ‘‘Default Init” resets all parameters to
their factory values. See also page 3-12 EEPROM Mode.
Note: This parameter can not be programmed while
the drive is running.
‘‘Store to EE”
‘‘Recll frm EE”
‘‘Default Init” Saves parameter Ram to EEPROM
Restores parameter Ram from EEPROM
Resets All Parameters to Their Factory Settings