Rockwell Automation 1305 AC Drive, Series A and B, Firmware 4.xx-5.xx User Manual
Page 39
Chapter 2 – Installation/Wiring
2-23
ADAPTERS
An adapter is any device connected to the drive’s serial port.
Typical devices include:
D Human Interface Modules
D Communication Modules
D Future adapter devices
IMPORTANT: A maximum of five adapters can communicate
to the drive.
The total current draw of all adapters should not exceed
250mA. Refer to the data sheet or nameplate of each adapter
for the amount of current needed for the adapter to operate.
The Adapter address is determined as follows:
D Port 1 equals Adapter 1.
D Port 2 equals Adapter 2. However, if a splitter is used to
expand the number of Adapters to 3, 4 or 5 the splitter will
be marked with the appropriate Adapter numbers.
Adapter Mounting Distance
The maximum mounting distance between any two adapters
connected to the drive is 10 meters. Refer to Figure 2.11.