Rockwell Automation 1305 AC Drive, Series A and B, Firmware 4.xx-5.xx User Manual
Page 12
Chapter 1 – Information and Precautions
1-2
2.Receiving – It is the responsibility of the user to thoroughly
inspect the equipment before accepting the shipment from the
freight company. Check the item(s) received against the
purchase order. If any items are obviously damaged, it is the
responsibility of the user not to accept delivery until the freight
agent has noted the damage on the freight bill. Should any
concealed damage be found during unpacking, it is again the
responsibility of the user to notify the freight agent. The
shipping container must be left intact and the freight agent
should be requested to make a visual inspection of the
equipment.
Unpacking – Remove all packing material from within and
around the drive.
IMPORTANT: Before the installation and start-up of the drive,
a general inspection of the mechanical integrity (i.e. loose
parts, wires, connections, etc.) should be made.
Inspection – After unpacking, check the item(s) nameplate
catalog number against the purchase order. An explanation of
the catalog numbering system for the Bulletin 1305 drive is
included as an aid for nameplate interpretation. Refer to the
following pages for complete nomenclature.
Storing – The drive should remain in its shipping container
prior to installation. If the equipment is not to be used for a
period of time, it must be stored according to the following
instructions in order to maintain warrranty coverage:
D Store in a clean, dry location.
D Store within an ambient temperature range of –40_ to
+70
_C.
D Store within a relative humidity range of 0% to 95%,
noncondensing.
D Do not store equipment where it could be exposed to a
corrosive atmosphere.
D Do not store equipment in a construction area.
3.GENERAL PRECAUTIONS
In addition to the precautions listed throughout this manual, the
following statements which are general to the system must be
read and understood.
The DC Bus Charge Indicator is a neon bulb that will be
illuminated when power is applied to the drive.