Rockwell Automation 1305 AC Drive, Series A and B, Firmware 4.xx-5.xx - Manual (Page 11)

1 Chapter Information and Precautions
1-1
CHAPTER OBJECTIVES
Chapter 1 provides information on the general intent of this
manual, gives an overall description of the Bulletin 1305
Adjustable Frequency AC Drive (herein called “the drive”) and
provides a listing of key drive options. Additionally, this
chapter provides information on receiving and handling the
drive.
1.MANUAL OBJECTIVES
The purpose of this manual is to provide the user with the
necessary information to install, program, start up and maintain
the Bulletin 1305 drive. To assure successful installation and
operation, the material presented must be thoroughly read and
understood before proceeding. Particular attention must be
directed to the ATTENTION and IMPORTANT statements
contained within.
Chapter 2 provides instructions on how to mount and wire the
drive. It also describes how to operate the drive without a Hu-
man Interface Module. Read the Motor Cable Length section
on pages 2-13 – 2-16, and the contact closure inputs informa-
tion in the Control Terminal Block descriptions on pages
2-19 – 2-21.
Chapter 3 defines the display and control panel keys on the
optional Human Interface Module. A flowchart is provided to
guide the user through the key strokes of the various menu
levels.
Chapter 4 describes the steps to start up the drive. It includes
a typical start up routine defining the adjustments and checks to
assure proper operation.
Chapter 5 outlines the parameter information of the drive such
as description, number, type, units, factory default, minimum
and maximum settings.
Chapter 6 defines the various drive faults and the appropriate
action to take as well as general troubleshooting information.
Appendix A contains a block diagram and general specifica-
tions of the drive.
Appendix B provides the necessary information for drive set up
using a PLC
R, SLC 
or other logic controller. A table is
provided that lists each parameter by parameter group with
space for the user to record any custom parameter settings.
Appendix C lists the accessories and their catalog number.
Appendix D lists requirements for CE conformity.
Index – A comprehensive index is provided to assist the user in
locating specific information. All parameters and fault in-
formation are listed alphabetically under parameters and faults
respectively.
PLC is a registered trademark of Allen-Bradley Company.
SLC is a trademark of Allen-Bradley Company.