Rockwell Automation 1305 AC Drive, Series A and B, Firmware 4.xx-5.xx - Manual (Page 17)

Installation/Wiring 2 Chapter
2-1
CHAPTER OBJECTIVES
Chapter 2 provides the information needed to properly mount
and wire the drive. Since most start-up difficulties are the
result of incorrect wiring, every precaution must be taken to
assure that the wiring is done as instructed. All items must be
read and understood before the actual installation begins.
ATTENTION: The following information is
merely a guide for proper installation. The
National Electrical Code and any other governing
regional or local code will overrule this
information. The Allen-Bradley Company cannot
assume responsibility for the compliance or the
noncompliance to any code, national, local or
otherwise for the proper installation of this drive
or associated equipment. A hazard of personal
injury and/or equipment damage exists if codes
are ignored during installation.
Figure 2.1 Mounting Requirements
НННННН
НННННН 50 mm
(2 in.)
100 mm
(4 in.)
75 mm
(3 in.)
ННН
ННН
ННН
ННН
ННН
ННН
ННННН
ННННН
IMPORTANT: The drive must be mounted to a metallic
surface.