Rockwell Automation 1305 AC Drive, Series A and B, Firmware 4.xx-5.xx - Manual (Page 74)

Chapter 5 – Programming
5-2
PARAMETER FLOW CHART
Metering Set Up
Advanced
Setup
Frequency
Set
Feature
Select
Output
Configuration
Faults
Output Current (54)
Output Voltage (1)
Output Power (23)
DC Bus Voltage (53)
Output Freq (66)
Freq Command (65)
MOP Hz (42)
Drive Temp (70)
Last Fault (4)
% Output Power (3)
% Output Curr (2) Input Mode (21)
Freq Select 1 (5)
Accel Time 1 (7)
Decel Time 1 (8)
Base Frequency (17)
Base Voltage (18)
Maximum Voltage (20)
Minimum Freq (16)
Maximum Freq (19)
Stop Select (10)
Current Limit (36)
Overload Mode (37)
Overload Current (38)
Sec Curr Limit (141) Minimum Freq (16)
Maximum Freq (19)
Base Frequency (17)
Base Voltage (18)
Break Frequency (49)
Break Voltage (50)
Maximum Voltage (20)
DC Boost Select (9)
Start Boost (48)
Run Boost (83)
PWM Frequency (45)
Analog Invert (84)
4-20 mA Loss Sel (81)
Stop Select (10)
DC Hold Time (12)
DC Hold Level (13)
DB Enable (11)
Motor Type (41)
Compensation (52) Freq Select 1 (5)
Freq Select 2 (6)
Jog Freq (24)
Prst/2nd Accel (26)
Upper Presets (72 )
Accel Time 2 (30 )
Decel Time 2 (31)
Preset Freq 1 (27)
Preset Freq 2 (28)
Preset Freq 3 (29)
Preset Freq 4 (73)
Preset Freq 5 (74)
Preset Freq 6 (75)
Preset Freq 7 (76)
Skip Freq 1 (32)
Skip Freq 2 (33)
Skip Freq 3 (34)
Skip Freq Band (35)
MOP Increment (22) Run On Power Up (14)
Reset/Run Tries (85)
Reset/Run Time (15)
S Curve Enable (57)
S Curve Time (56)
Language (47)
Balance Freq (80) ➀
Balance Time (79) ➀
Balance Angle (78) ➀
Cable Length (143) ➁ Output 1 Config (90)
Output 2 Config (91)
Analog Out Sel (25)
Above Freq Val (77)
Above Curr Val (142) Fault Buffer 0 (86)
Fault Buffer 1 (87)
Fault Buffer 2 (88)
Fault Buffer 3 (89)
Clear Fault (51)
Cur Lim Trip En (82)
Line Loss Fault (40)
Flt Clear Mode (39)
Page 5-5 Page 5-8 Page 5-15 Page 5-25 Page 5-32 Page 5-37 Page 5-39
Wrap to Linear List
Bold indicates parameters located in more than one group.
➀
FRN 4.01 and below only.
➁ FRN 4.01 and above only.