Jeppesen JeppView 3 - Manual (Page 176)

RoutePacks and Route Planning
179
3. Although not required, you can enter the following in the Route field to help
create your route:
• Waypoint identifiers (such as airports, navaids, or intersections) along
your route.
• Enter LOW or HIGH to route along the low or high enroute airway
system.
• To specify an airway, enter the Victor or Jet airway number (V220,
J151
). When assigning Victor and Jet airways, you also need to assign
an airway entry, exit or Enroute Airspace Fix on both sides of the
airway. For example, PNH V280 FRAIZ. When changing from one
airway to another, the correct connector must be supplied.
• Enter VNA in the Route field to plan a route using VORs, NDBs and
airports.
• Enter DIRECT to plan a route or segment with a direct flight to another
waypoint (for example, LOXZ DIRECT VIC LOW LIRE, where LOXZ is
the departure airport; LIRE is the destination airport, and DIRECT VIC
LOW is entered in the Route field).
• To enter more than one item, place a space between each one (as
shown above).
4. When route entry is complete, click Next.
5. Although not required, you can enter the identifier for an alternate airport in
the field on the left. When the identifier is entered, the name of the airport
appears to the right.
6. To add the airport as an alternate, click Add. Once an alternate has been
added, it can be deleted by selecting Remove. An unlimited number of
alternates can be added. On the enroute chart, a straight line appears from
the destination airport to any alternate airports identified.
7. When the alternates have been added, click Next.