Jeppesen JeppView 3 - Manual (Page 183)

JeppView User's Guide
186
Routes are created and stored in a RoutePack. There are two ways to create a route,
as described below or by using the
RoutePack Wizard . A route must be contained in a
RoutePack, which is collection of one or more routes, airports, and charts.
Before creating a route, you must select or create a RoutePack to contain it.
To create a route without the Route Wizard:
1. Do any of the following:
• Right-click a RoutePack in the RoutePack List and choose Add Route
(Point/Click).
• Select a RoutePack in the RoutePack List, right-click in an open space
on the Enroute Charts view, and then choose Add Route to
RoutePack.
• Select a RoutePack in the RoutePack List and then click File > Add
Route to RoutePack.
Any of these actions displays the Route Properties dialog box, which
contains information about the route such as the distance, alternate airports,
waypoints, and charts. The only thing you can enter is the route name.
2. Accept the default name or enter a new one, and then click OK.
The new route appears in the RoutePack List. The Append Waypoints function
activates in the Enroute Charts View, enabling you to point and click the
airports and waypoints along your route.
3. In the Enroute Charts view, select your departure airport.
The airport appears in the RoutePack List under the new route.
4. in the Enroute Charts view, click the route waypoints in sequence (if
applicable) and then your destination airport.