Jeppesen JeppView 3 - Manual (Page 48)

Installation and Activation
51
2. Check for the terminal chart coverages that you have purchased under your
serial number, and click Next.
A. The first time you install the ECD Disc 1 on a given computer, you might
not see any coverages. If that occurs, a box appears near the bottom of
the Setup window for entering a coverage code.
B. Type the coverage codes from the back of your JeppView CD album (below
the Serial Number), and then click Apply.
NOTE
Coverage codes change with each terminal chart cycle. If the coverage code
you have no longer works, or you don’t have a coverage code, or you don’t see
the coverages you need after entering any codes you have, have your order
number or customer number available and
call Jeppesen Customer Service .
Once you have the codes you need, complete the steps outlined below.
C. If necessary, restart the ECD Disc 1 Setup program.
D. On the Coverages screen, select the I have additional Coverage Codes
check box, and then click Next. Setup displays a box into which you type
additional codes.
E. Enter any coverage codes you have, and then click Apply.