Jeppesen JeppView 3 - Manual (Page 66)

Installation and Activation
69
NOTE
If you try to reactivate JeppView or NavSuite on this machine after
activating them on another computer, or activate the products on a
fifth machine without deactivating one site key, you will receive a
message from the server that your site key limit has been exceeded.
To purchase and activate additional installation of JeppView or
NavSuite, please contact Jeppesen Customer Service .
If JeppView is inaccessible, resulting from a hard disk crash, for example, contact a
Technical Support Representative by phone or email for assistance.
Removing JeppView and FliteDeck
To remove JeppView, FliteDeck, or both applications, from your computer:
1. Open the Control Panel.
The procedure for opening the Control Panel depends on the Operating System
and if you are using the Classic view. Try one of the following:
• Open My Computer and click the Control Panel on the left panel.
• Click Start > Settings > Control Panel.
• Click Start > Control Panel.
2. Choose Add or Remove Programs.
3. Click JeppView Program or Jeppesen NavSuite.
4. Select which action to perform:
• Modify — Removes (or adds) a single program or a program option.
Click Next and follow the instructions in the Wizard. Clear the check
boxes for the components that you would like to remove from your
computer (you cannot clear both FliteDeck and JeppView). If you want
to remove both programs, click Cancel, then restart and select
Remove.
• Remove — Removes all the programs. Click Next and follow the
instructions in the Wizard. Jeppesen highly recommends that you
choose Yes when asked about deactivating the programs. Deactivating
allows you to install and run the software on another computer (see
Deactivating JeppView for additional information).
IMPORTANT
Select Remove only if you want to uninstall both JeppView
and FliteDeck or all the programs in the NavSuite.