Jeppesen JeppView 3 - Manual (Page 205)

JeppView User's Guide
208
Updating a RoutePack
When you update JeppView, RoutePacks that were created and saved in a previous
cycle need to be refreshed to obtain the latest chart information. When charts are
available that are newer than those loaded in the RoutePack, a message appears
upon opening that RoutePack. JeppView automatically updates the terminal charts
when opened. After the RoutePack is updated, the RoutePack name displays as
Modified until you save it. To save the updated charts with the RoutePack, you must
save it either by right-clicking on the RoutePack and choosing Save or by clicking
File > Save.
If you load a RoutePack that has filtered out certain charts, you might receive a
message similar to that shown below, which means that terminal charts associated
with the airports in the selected RoutePack have been updated, although they are
not contained in that RoutePack because of terminal chart filters set in the RoutePack
List (see
Filtering Terminal Charts in the RoutePack ). To load the charts listed in the
message, right-click the RoutePack and choose Reset to current Chart Type
Preferences. Save the RoutePack to view the charts the next time you open the
RoutePack.
See also:
JeppView Revisions
RoutePack Properties
The RoutePack Properties dialog box provides basic information about routes in the
RoutePack. Status lines below the edit fields display the dates and times the
RoutePack was first created, last changed, and last printed.
Use one of the following techniques to open the RoutePack Properties dialog box:
• Right-click the RoutePack in the RoutePack List and click Properties.