Jeppesen JeppView 3 - Manual (Page 188)

RoutePacks and Route Planning
191
• RoutePack List
• Search dialog box
Using the Rubberband Method on the Enroute Chart
To insert a waypoint using the rubber-band method on the enroute chart:
1. Point to the route line on the enroute chart.
2. Press the mouse button and, while holding it, drag the route line onto the
desired waypoint.
You do not have to drag the route to an existing waypoint. If you drag it to a location
that is not an airport, navaid, or intersection; JeppView creates a new waypoint
where you release the mouse button.
The new waypoint appears on the RoutePack List and the enroute chart redraws to
reflect the new route waypoint.
TIP
To change (not insert) a waypoint using the rubber-band method, grab the
route line at a waypoint, drag it off that waypoint to a new waypoint.
Using the Airport List
You can use the Airport List to insert waypoints into a route using the drag-and-drop
or copy- and-paste methods described below.
The object in the RoutePack List that you drag or paste the airport into determines
where that airport is inserted along the route.
• To insert a new departure airport, drag or paste it on the first airport in the
route.
• To insert an airport as an enroute waypoint, drag or paste it onto the
waypoint that will follow the inserted waypoint.
• To append an airport as the new destination, drag or paste it onto the route
name.
• To add an airport to the RoutePack’s Other Charts folder, drag or past it onto
the RoutePack name (see Adding Other Charts to a RoutePack ).