Jeppesen JeppView 3 - Manual (Page 216)

Printing
219
• NOTAMS prints terminal chart NOTAMS (the NOTAMS tab content)
associated with the selected RoutePack or route.
• Airport Information prints airport information (General, Runway,
Communication, or Notebook) for airports in the selected RoutePack
or route.
• JeppView Charts for [RoutePack] prints all the terminal charts for
airports in the selected RoutePack or route. This does not include
charts that have been filtered out or deleted in the RoutePack list.
4. Select the Page Settings options.
• If you make no selection, JeppView prints charts scaled to fill an entire
page. To print in single-page mode, clear the Two per page check
box.
• Two per page prints two charts on each page, the same size as
standard printed charts, maximizing each chart on its half of the page,
in one of four ways:
o
Kneeboard prints with standard margins, designed for use with
chart clipboards.
o
Jeppesen Paper (2 up) prints to Jeppesen 8.5-by-11-inch paper
with 7-hole punches down the center and edge (Jeppesen part #
AJV33003) for placement in Jeppesen binders.
o
Jeppesen Paper (1 up) prints to Jeppesen 8.5-by-11-inch paper
with 7-hole punches down the left and right edges showing one
chart upside down (Jeppesen part # AJV33002) for placement in
Jeppesen binders. In the print preview orientation with duplex
printing, charts display two-up, but print correctly.
NOTE
The Jeppesen Paper options are available for terminal charts and Revision
letters only. When selecting any of the options under the Vector Chart
section, NOTAMS, or Airport Information, the Jeppesen paper selections
become unavailable.
o
Booklet prints terminal charts in a sequence that allows you to
fold all the printed sheets in the middle and place the charts in an
8.5-by-5 inch booklet format. In order for the Booklet option to be
available, you must have only the following options selected:
JeppView Charts for 'RoutePack/Route', Two per page, and
Print on both sides.