Jeppesen JeppView 3 - Manual (Page 187)

JeppView User's Guide
190
The Route Wizard guides you through a series of dialog boxes to create a route with
alternate airports and waypoints (if desired). To create a route using the Route
Wizard:
1. Open the Route Wizard by doing either of the following:
• Right-click the RoutePack name for the new route and choose Add
Route (Wizard).
• Select the RoutePack for the new route or any route or waypoint in
that RoutePack, and then click File > Add Route to RoutePack.
2. Follow steps 2 through 6 as described in Creating a RoutePack .
3. On the third Route Wizard screen, type the Route Name (or use the default).
4. Click Finish.
Airports and terminal charts can be added to and removed from existing routes. To
edit routes, you may use the Re-plan this Route Wizard by right-clicking on the
route name in the RoutePack List, or using one of the following techniques:
• Inserting Waypoints into a Route
• Appending Waypoints to a Route
• Deleting Route Objects
Modify a Route
After you create a route, you can modify it by inserting, appending, deleting, or
rearranging route waypoints. You can also reverse the route or add alternate routes
to it.
• Inserting Waypoints into a Route
• Appending Waypoints to a Route
• Deleting Route Objects
• Replanning a Route
• Rearranging Waypoints in a Route
• Reversing the Route
• Adding an Alternate Route
• Renumber Route Waypoints
Inserting Waypoints into a Route
Inserting adds a waypoint to the beginning or middle of an existing route in the
RoutePack List. (To add a waypoint to the end of a route, see Appending Waypoints
in this chapter.) When the inserted route waypoint is an airport, the system adds
that airport and all its associated terminal charts to the route.
You can insert a waypoint into an existing route in four ways:
• Rubber-band method on the enroute chart
• Airport List