Pioneer SX-209RDS - Manual (Page 62)

I
Amplifier Section
Continuous Power Output (DIN)*
1 kHz, T.H.D. 1 %, 4 Q......................................... 50 W + 50 W
Continuous Power Output (both channels driven)* **
20 Hz - 20 kHz, T.H.D. 0.09 %, 8 Q ...................... 40 W + 40 W
Dynamic Power Output (with EIA test signal)
4/8 ill........................................................................... 80/50 W
• Above specifications are for when power supply is 230V.
Input (Sensitivity/lmpedance)
PHONO................................................................ 2.5mV/47ki2
CD, LD/DVD, TAPE WCR, TAPE 2......................... 200 mV/22 kQ
Phono Overload Level (T.H.D. 0.1 %, 1 kHz)
PHONO......................................................................... 100 mV
Output (Level/Impedance)
TAPE 1A/CR REC, TAPE 2 REC MONITOR .............. 200 mV/1 kQ
Frequency Response
PHONO (RIAA Equalization)........... 20 Hz to 20,000 Hz ± 0.5 dB
CD, LD/DVD, TAPE 1/VCR, TAPE 2 .... 5 Hz to 100,000 Hz -3 dB
Signal-to-Noise Ratio (DIN, continuous power/50mW)**
PHONO.................................................................. 67dB/61 dB
CD, LD/DVD, TAPE WCR, TAPE 2............................ 82 dB/62 dB
Tone Control
BASS................................................................... ±8dB(100Hz)
TREBLE................................................................ ±8dB(10kHz)
LOUDNESS.............................................. +6dB(100Hzat-40dB)
+4 dB (10 kHz at -40 dB)
AM Tuner Section
Frequency Range.......................................... 531 kHz to 1,602 kHz
Sensitivity
IHF, Loop Antenna.............................. ...................... 350 pV/m
Selectivity................................................................................... 20 dB
Signal-to-Noise Ratio................................................................. 50 dB
Antenna........................................................... AM Loop Antenna
Miscellaneous
Power Requirements....................... a.c. 220 - 230 Volts, 50/60 Hz
Power Consumption...................................................................370 W
Dimensions............................... 420 (W) X 140 (H) X 313 (D) mm
Weight (without package)............................................................5.4 kg
Furnished Parts
FM Antenna................................................................................ 1
AM Loop Antenna..................................................................... 1
Remote Control Unit.................................................................. 1
Dry Cell Batteries (AA/R6P) ........................................................ 2
Operating Instructions................................................................ 1
NOTE:
Specifications and design subject to possible modification with­
out notice due to improvements.
* Measured by audio spectrum analyzer.
** Direct ON.
FM Tuner Section
Frequency Range......................................... 87.5 MHz to 108 MHz
Usable Sensitivity................................ 14.2 dBf, IHF (1.4 pV/75 i^)
Sensitivity (DIN)
MONO.............. ..................................................... 1.0 MV/75Ì2
STEREO.................................................................... 40pV/75n
SIgnal-to-Nolse Ratio
MONO........................................................... 77 dB (at 80 dBf)
STEREO.......................................................... 72 dB (at 80 dBf)
Signal-to-Nolse Ratio (DIN)
MONO.............................................................................. 62 dB
STEREO............................................................................ 58 dB
Distortion
STEREO................................................................. 0.3% (1 kHz)
Alternate Channel Selectivity................................ 64 dB (400 kHz)
Stereo Separation..................................................... 40 dB (1 kHz)
Frequency Response................................ 30 Hz to 15 kHz (±1 dB)
Antenna Input..................................................... 75 Q unbalanced
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by
tugging the cord and never touch the power cord when your
hands are wet as this could cause a short circuit or electric shock.
Do not place the unit, a piece of furniture, etc., on the power
cord, or pinch the cord. Never make a knot in the cord or tie it
with other cords. The power cords should be routed such that
they are not likely to be stepped on. A damaged power cord can
cause fire or give you an electrical shock. Check the power cord
once In a while. When you find it damaged, ask your nearest
PIONEER authorized service center or your dealer for a replace­
ment.
MAINTENANCE OF EXTERNAL SURFACES
• Use a polishing cloth or dry cloth to wipe off dust and dirt.
• When the surfaces are very dirty, wipe with a soft cloth
dipped in some neutral cleanser diluted five or six times
with water, and wrung out well, and then wipe again with
a dry cloth. Do not use furniture wax or cleaners.
• Never use thinners, benzine, insecticide sprays and other
chemicals on or near this unit, since these will corrode the
surfaces.
Published by Pioneer Corporation.
Copyright © 1999 Pioneer Corporation.
All rights reserved.
62
<XRD1002>
En