Comtrol AT Commands for SmartACFL - Manual (Page 110)

Command Reference Manual
4-4 Conexant 100722A
4.2 COMMANDS AND PARAMETERS
4.2.1 Mode Entry Commands
4.2.1.1 +FCLASS=1 - Select Facsimile Class 1 Mode
+FCLASS=1 selects the Fax Class 1 Mode. The Fax Class 1 Mode commands and responses described in this section are
applicable when command +FCLASS=1 as shown in Table 4-1. (See Section 3.2.1.2 for the definition of the FCLASS
command.)
4.2.1.2 +FCLASS=1.0 - Select Facsimile Class 1.0 Mode
+FCLASS=1.0 selects the Fax Class 1.0. The Fax Class 1.0 Mode commands and responses described in this section are
applicable when command +FCLASS=1.0 as shown in Table 4-1. (See Section 3.2.1.2 for the definition of the FCLASS
command.)
4.2.2 Mode Commands
4.2.2.1 +FAA - Auto Answer Enable
This command enables or disables fax adaptive answer. This command operates identically to the +FAE command.
Syntax
+FAA=<value>
Defined Values
<value> Decimal number corresponding to the selected option.
0 Disable data /fax auto answer mode. (Default.)
1 Enable data /fax auto answer mode. The modem determines the calling type and
issues DATA result code (13) if the caller is a data modem or issues FAX result
code (15) if the caller is a fax modem.
4.2.2.2 +FAE - Auto Answer Enable
This command enables or disables fax adaptive answer. This command operates identically to the +FAA command.
Syntax
+FAE=<value>
Defined Values
<value> Decimal number corresponding to the selected option.
0 Disable data /fax auto answer mode. (Default.)
0 Enable data /fax auto answer mode. The modem determines the calling type and
issues DATA result code (13) if the caller is a data modem or issues FAX result
code (15) if the caller is a fax modem.
After a data (not fax) connection is achieved (indicated by the DATA result code), the DTE must issue an ATO command to
cause the modem to go on-line.