Comtrol AT Commands for SmartACFL - Manual (Page 17)

Command Reference Manual
100722A Conexant 2-5
2.4.4.2 Parameter Set Command Syntax
The definition of the parameter indicates, for each value, whether the specification of that value is mandatory or optional. For
optional values, the definition indicates the assumed (default) value if none is specified; the assumed value may be either a
previous value (i.e., the value of an omitted subparameter retains its previous value), or a fixed value (e.g., the value of an
omitted subparameter is assumed to be zero). Generally, the default value for numeric parameters is 0, and the default value
for string parameters is "" (empty string).
The following syntax is used for parameters that accept a single value:
+<name>=[<value>]
The following syntax is used for parameters that accept more than one value:
+<name>=[<compound_value>]
For each implemented parameter, if all mandatory values are specified, and all values are valid according to the definition of
the parameter, the specified values are stored. If <name> is not recognized, one or more mandatory values are omitted, or
one or more values are of the wrong type or outside the permitted range, the modem issues the ERROR result code and
terminates processing of the command line. An ERROR is also generated if too many values are specified. In case of an
error, all previous values of the parameter are unaffected.
2.4.4.3 Parameter Read Command Syntax
The DTE may determine the current value or values stored in a parameter by using the following syntax:
+<name>?
The modem responds by sending the current values stored for the parameter to the DTE in an information text response. The
format of this response is described in the definition of the parameter. Generally, the values are sent in the same form in
which they would be issued by the DTE in a parameter setting command; if multiple values are supported, they will generally
be separated by commas, as in a parameter setting command.
2.4.4.4 Parameter Test Command Syntax
The DTE may test if a parameter is implemented in the modem, and determine the supported values, by using the syntax:
+<name>=?
If the modem does not recognize the indicated name, it returns an ERROR result code and terminates processing of the
command line. If the modem does recognize the parameter name, it returns an information text response to the DTE, followed
by an OK result code. The information text response indicates the values supported by the modem for each such
subparameter, and possibly additional information. The format of this information text is defined for each parameter.
2.4.5 Additional Syntax Rules
2.4.5.1 Concatenating Commands after Extended Syntax Commands
Additional commands may follow an extended-syntax command on the same command line if a semicolon (";") is inserted
after the preceding extended command as a separator. The semicolon is not necessary when the extended syntax command
is the last command on the command line.
2.4.5.2 Concatenating Commands after Basic Format Commands
Extended syntax commands may appear on the same command line after a basic syntax command without a separator, in
the same manner as concatenation of basic syntax commands.