Comtrol AT Commands for SmartACFL - Manual (Page 113)

Command Reference Manual
100722A Conexant 4-7
4.2.2.6 +FRM - Receive Facsimile
This command causes the modem to enter the receiver mode using the modulation defined below.
Syntax
+FRM=<mod>
Defined Values
<mod> Decimal number corresponding to the selected modulation mode and data rates shown in Table
4-2.
Reporting Current or Selected Values
Command: +FRM?
Response:
+FRM: <mod>
Example: +FRM: 98 For V.17 9600 bps.
Reporting Supported Range of Parameter Values
Command: +FRM=?
Response:
+FRM: (<mod> range)
Example: +FRM: 3,24,48,72,73,74,96,97,98,121,122,145,146
Result Codes
CONNECT Reported when the selected carrier is detected.
+FCERROR Reported if another carrier is detected and FAR=0; the modem then returns to the command state.
NO CARRIER Reported if loss-of-carrier is detected.
OK Reported if the DTE sends any character to the modem other than XON or XOFF while operating
in configured flow control from the DTE; the modem then returns to the command state.