Comtrol AT Commands for SmartACFL - Manual (Page 159)

Command Reference Manual
100722A Conexant 6-15
6.2.2.12 +VSM - Compression Method Selection
This command causes the modem to set the voice compression method, the silence compression sensitivity, and the voice
sampling rate.
Syntax
+VSM=<cml>,<vsr>,<sds>,<sel>
Defined Values
<cml> Decimal number identifying the compression method.
<vsr> <range of values> containing the supported range of voice samples per second of the analog
signal.
<scs> <range of values> containing the supported range of sensitivity settings for voice receives.
<sel> <range of values> containing the supported range of expansion values for voice transmits.
Reporting Current or Selected Values
Command: +VSM?
Response:
<cml>,<vsr>,<sds>,<sel>
Example: 1,8000,0,0 Default
Reporting Supported Range of Parameter Values
Command: +VSM=?
Response:
<cml>,<cmid>,<bps>,<tm>,<vsr>,<sds>,<sel>
<cml> Decimal number identifying the compression method (1, 129, 130, 140, or 141).
<cmid> Alphanumeric string describing the compression method (UNSIGNED PCM, IMA ADPCM,
UNSIGNED PCM, 2 Bit ADPCM, or 4 Bit ADPCM).
<bps> Decimal number defining the average number of bits in the compressed sample not including
silence compression (2, 4 or 8).
<tm> Decimal number (0) reporting the time interval, in units of 0.1 second, between timing marks. A
value of 0 reports that timing marks are not supported.
<vsr> <range of values> containing the supported range of voice samples per second of the analog
signal (8000).
<scs> <range of values> containing the supported range of sensitivity settings for voice receives (0). A 0
indicates not supported.
<sel> <range of values> containing the supported range of expansion values for voice transmits (0). A 0
indicates not supported.
Example: 1,"UNSIGNED PCM",8,0,8000,0,0
129,"IMA ADPCM",4,0,8000,0,0
130,"UNSIGNED PCM",8,0,8000,0,00
140,"2 Bit ADPCM",2,0,8000,0,0
141,"4 Bit ADPCM",4,0,8000,0,0
OK
Result Codes
OK Valid range.
ERROR Otherwise, or if not in Voice Mode.