Comtrol AT Commands for SmartACFL - Manual (Page 53)

Command Reference Manual
100722A Conexant 3-33
3.2.3.18 –PPD= - Extension Pickup Notification through 16550 UART
The –PPD=1 command allows setting of the DDSR (bit 1 of register 6) when an extension pick-up is detected, and disables all
DSR notification. The –PPD=0 command disables this feature.
This feature is available only on a SmartSCM that is configured for parallel operation.
3.2.3.19 –STE= - Set Telephony Extension
The –STE command enables/disables Line-In-Use, Extension Pickup, and Remote Hangup detection features.
NOTE: This command is supported only if enabled through firmware configuration (see product release notes).
Syntax
-STE=<value>
Defined Values
<value> Decimal number corresponding to the selected bit-mapped options. The bit field are defined as
follows:
Bit 0 = Line-In-Use detection enable/disable.
Bit 1 = Extension Pickup detection enable/disable.
Bit 2 = Remote Hangup detection enable/disable.
<value> (Dec.) Remote Hangup Extension Pickup Line-In-Use
0 (default) Disabled Disabled Disabled
1 Disabled Disabled Enabled
2 Disabled Enabled Disabled
3 Disabled Enabled Enabled
4 Enabled Disabled Disabled
5 Enabled Disabled Enabled
6 Enabled Enabled Disabled
7 Enabled Enabled Enabled
Reporting Current or Selected Values
Command: -STE?
Response:
-STE: <value>
Example: -STE: 4 Remote Hangup enabled, Extension Pickup disabled, and Line-In-Use disabled
Reporting Supported Range of Parameter Values
Command: -STE=?
Show available options
Response: -STE: 0-7
Result Codes
OK <value> = 0-7
ERROR Otherwise.
Behavior in Data Mode (+FCLASS=0)
When on-hook, if the line is in use and an ATDT is issued, the modem will not go off-hook and will return with the message
LINE-IN-USE.
When off-hook and either an extension is picked up or a line reversal is detected, the modem will drop the connection. The
disconnect reason in register S86=25 (this is also defined for #UD). The user must flash the hook in order to get a dial tone
due because the remote server will be retraining.
If the local handset is picked up while the modem is off-hook, the modem will do a link-disconnect, flash the hook for 1.5
seconds, then connect the local handset to the line. At this point, the user dial tone should be on the local handset. The
disconnect reason in S86=25.