Conexant – Comtrol AT Commands for SmartACFL User Manual
Page 52
Command Reference Manual
3-32
Conexant
100722A
3.2.3.15 %Q - Report Line Signal Quality
Reports the line signal quality (DAA dependent). Returns the higher order byte of the EQM value. Based on the EQM value,
retrain or fallback/fall forward may be initiated if enabled by %E1 or %E2.
Example:
AT%Q
015
Result Codes
OK
If connected.
ERROR
If not connected, or connected in 300 bps, V.23, or fax modes.
3.2.3.16 *B - Display Blacklisted Numbers
This command requests the modem to return a list of blacklisted numbers to the DTE. The format of the response is shown by
the example below. Permanently forbidden numbers as defined by country requirements will not appear on this list. If no
numbers are blacklisted, only the OK result code is issued.
Syntax
*B
Example
NO. - PHONE NUMBER -
------ ------------------------------
1;
4175537660
2;
8288924961
3;
3887278862
4;
3124839442
5;
6284664
OK
3.2.3.17 *D - Display Delayed Numbers
This command causes the modem to send a list of the delayed numbers together with the delay associated with each. The
modem will return a list of delayed telephone numbers as defined in the *B command. The format of the response is shown by
the example below (delay times are shown as hours:minutes:seconds). If no numbers are delayed, only the OK result code is
issued.
Syntax
*D
Example
NO. - PHONE NUMBER -DELAY
------ -------------------------------------------
1;
8264734660
2:00:00
2;
7532634661
2:00:00
3;
2587334662
0:02:00
4;
7532651663
0:03:25
5;
7459931664
0:01:45
OK