Comtrol AT Commands for SmartACFL - Manual (Page 132)

Command Reference Manual
5-10 Conexant 100722A
5.3.5.2 Continue Document Reception
The DTE may issue a +FDR command in Phase D, which releases the post page message, and indicates readiness to
receive another page after receipt of a Multipage (+FET:0) or PPS-NULL (+FET:3) message. The DCE response will be:
CONNECT
(<DC2> needed from DTE here)
<Phase C data stream)
<DLE><ETX>
+FPTS:<ppr>, <lc> [,<blc>, <cblc>]
+FET:<ppm>
OK
(DTE must issue +FDR command to release post page response)
If done receiving:
+FHNG: <hangup cause code>
OK
Continue page reception
5.3.5.3 Phase C Data Framing
Phase C data may be presented to the DTE in stream mode. The DCE will transfer a stream of data to the DTE, followed by
the <DLE><ETX> stream termination characters. The DCE will filter the stream as described in Section 6.1.2.
5.3.5.4 Phase C Data Format
The received data format is negotiated under T.30 reported by the +FDCS:VR,BR,WD,LN,DF,EC,BF,ST response.
The DCE will delete the terminating RTC (6 EOLs) patterns.
5.3.5.5 <CAN> - Escape from Reception
From the +FDR command until the end of Phase D Date, the DCE is in a data transfer state, and will not respond to DTE
command characters. The DCE will respond to three ASCII control characters: <DC1> (017) and <DC3> (019) flow control
characters, and cancel <CAN> (024).
Upon receipt of the <CAN> character, the DCE will terminate the reporting of received data by sending trailing <DLE><ETX>
characters to the DTE, and will then execute an implied +FK command in order to conduct an orderly disconnection.
5.3.6 +FK - Session Termination
Syntax: +FK
The +FK command causes the DCE to terminate the session in an orderly manner. In particular, the DCE will send a DCN
message at the next opportunity and hang up. At the end of the termination process, the DCE will report the +FHNG response
with result code (Table 5-5).
This operation can be invoked by using the cancel <CAN> character during Phase C data reception (see prior section)
The DCE will wait until the current page completes, unless the reception is of unlimited length; in that case, the DCE may halt
reception and terminate the session at any time.