Comtrol AT Commands for SmartACFL - Manual (Page 44)

Command Reference Manual
3-24 Conexant 100722A
Reporting Supported Range of Parameter Values
Command: +ILRR=?
Response:
+ILRR: (<value> range)
Example: +ILRR: (0,1)
Reported Rate
The <rate> reported represents the current (negotiated or renegotiated) DTE-modem rate. If enabled, the intermediate result
code is transmitted after any modulation, error control or data compression reports are transmitted, and before any final result
code (e.g., CONNECT) is transmitted. The <rate> is applied after the final result code is transmitted.
The DTE-modem port rate will change only if neither buffered mode nor error controlled means are enabled (+ES=x,0) and if
the negotiated carrier rate (+MRR) does not match the current DTE-modem port rate (autodetected from the previous
command line).
Syntax
+ILRR: <rate>[,<rx_rate>]
Defined Values
<rate> Decimal value representing the current (negotiated or renegotiated) DTE-modem rate:
0, 300, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, or 230400
<rx_rate> Optional decimal value reporting the RXD rate, if it is different from the TXD rate:
0, 300, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, or 230400
Example
+ILRR: 19200
3.2.3 Call Control
3.2.3.1 D - Dial
This command directs the modem to go on-line, dial according to the string entered and attempt to establish a connection. If
no dial string is supplied, the modem will go on-line and attempt the handshake in originate mode.
NOTE: If the ATD command is issued before the S1 register has cleared, the modem will respond with the NO CARRIER
result code.
If +FCLASS=0 is selected, the modem will behave as a data modem and will attempt to connect to another data modem. The
modem will have up to the period of time specified by register S6 or S7 to wait for carrier and complete the handshake. If this
time expires before the modem can complete the handshake, the modem will go on-hook with the NO CARRIER response.
This command will be aborted in progress upon receipt of any DTE character before completion of the handshake.
If +FCLASS=1, 1.0, or 2 is selected, the modem will behave as a facsimile modem and attempt to connect to a facsimile
machine (or modem) by entering the HDLC V.21 channel 2 receive state (as if +FRH=3 had been issued). This command will
be aborted upon receipt of any DTE character if the modem has not finished dialing. In this case, the modem will go on-hook
and return to command mode after displaying the NO CARRIER message. If the modem has finished dialing, it proceeds as if
the +FRH=3 command has been issued. (Refer to the +FRH command to determine how the modem behaves following this
stage.)
Dial Modifiers
The valid dial string parameters are described below. Punctuation characters may be used for clarity, with parentheses,
hyphen, and spaces being ignored.
Syntax
D<string>