Comtrol AT Commands for SmartACFL User Manual
Page 23
Command Reference Manual
100722A
Conexant
3-3
3.2.1.4 +VRID - Report Retrieved Caller ID (CID)
This command reports the data associated with the Caller ID services in the Incoming Call Line ID (ICLID) data format for the
last received call.
Syntax
+VRID=<pmode>
Defined Values
<pmode>
Decimal number corresponding to the selected option.
0
Reports Caller ID with formatted presentation to the DTE. The modem presents the
data items in a <Tag><Value> pair format. The expected pairs are date, time,
name, and caller code (telephone number),
1
Reports Caller ID with unformatted presentation to the DTE.
Reporting Supported Range of Parameter Values
Command: +VRID=?
Response:
+VRID: (<pmode> range)
Example:
+VRID: (0,1)
3.2.1.5 \N - Operating Mode
This command controls the preferred error correcting mode to be negotiated in a subsequent data connection. This command
is affected by the OEM firmware configuration.
Syntax
\N<mode>
Defined Values
<mode>
Decimal number which corresponds to the selected mode.
0
Selects normal speed buffered mode (disables error-correction mode). (Forces
&Q6.)
1
Serial interface selected - Selects direct mode and is equivalent to &M0, &Q0
mode of operation. (Forces &Q0.)
Parallel interface selected - Same as \N0.
2
Selects reliable (error-correction) mode. The modem will first attempt a LAPM
connection and then an MNP connection. Failure to make a reliable connection
results in the modem hanging up. (Forces &Q5, S36=4, and S48=7.)
3
Selects auto reliable mode. This operates the same as \N2 except failure to make
a reliable connection results in the modem falling back to the speed buffered
normal mode. (Forces &Q5, S36=7, and S48=7.)
4
Selects LAPM error-correction mode. Failure to make an LAPM error-correction
connection results in the modem hanging up. (Forces &Q5 and S48=0.) Note: The
-K1 command can override the \N4 command.
5
Selects MNP error-correction mode. Failure to make an MNP error-correction
connection results in the modem hanging up. (Forces &Q5, S36=4, and S48=128.)
Result Codes
OK
<mode> = 0 to 5.
ERROR
Otherwise.