Comtrol AT Commands for SmartACFL - Manual (Page 140)

Command Reference Manual
5-18 Conexant 100722A
5.5.4 +FLID= - Local ID String
Write syntax: +FLID="<local ID string>"
Valid value: 20-character ASCII string
Default value: Empty
If FLID is not a null string, it generates a TSI or CSI frame. Table 3/T.30 includes digits 0-9, “+” and space.
If the DCE supports use of Table 3/T.30 only, the response to a +FLID=? command is “(20) (32, 43, 48-57).” If the DCE
supports printable ASCII <, the response is: “(20) (32-127)<CRLF>.” The first “(20)” represents string length: the second
(character values) field reports supported string values.
1. The string is saved in RAM.
2. Non-numeric characters are not filtered out.
3. The string is right justified.
5.5.5 +FCR - Capability to Receive
Write syntax: +FCR=<value>
Valid values: 0 or 1
Default value: 0
+FCR=0 indicates that the DCE will not receive message data. This can be used when the DTE has insufficient storage. The
DCE can send and can be polled for a file.
+FCR is sampled in CCITT T.30 Phase A and Phase D.
5.5.6 +FPTS= - Page Transfer Status
Write Syntax: +FPTS=<ppr>
Valid values: 1, 2, 3, 4, 5
Default value: 0
The +FPTS parameter contains a value representing the post page response, including copy quality and related end-of-page
status. These values correspond to post page response messages defined in T.30. The receiving DCE sets this parameter
after it receives a page of Phase C data. The transmitting DCE sets this parameter with the status reported by the receiving
station. The DTE may inspect or modify this parameter.
The set of <ppr> values is defined in Table 5-4. These values are also reported in the +FPTS response to the +FDR
command.
5.5.7 +FCQ - Copy Quality Checking
Write syntax: +FCQ=<value>
Valid values: 0
Default value: 0
This parameter controls Copy Quality checking by a receiving facsimile DCE.
The DCE returns +FCQ=0 which indicates the DCE does no quality checking. The DCE will generate Copy Quality OK (MCF)
responses to complete pages, and set +FPTS=1.
5.5.8 +FPHCTO - DTE Phase C Response Time-out
Write syntax: +FPHCTO=<value>
Valid values: 0 - 255, 100 millisecond units.
Default value: 30
The +FPHCTO command determines how long the DCE will wait for a command after reaching the end of data when
transmitting in Phase C. When this time-out is reached, the DCE assumes there are no more pages and no documents to
send. It then sends the T.30 EOP response to the remote device.