Keri Systems Doors.NET Manual - Manual (Page 23)

Doors.NET Reference Manual
- 23 -
Unique to PXL Controllers:
NOTE: For PXL installations, Keri strongly recommends upgrading to the 3.5.1.18
release to take advantage of the improvements made for data throughput and event col-
lection, and for master/slave controller updating.
l
Made multiple improvements in data handling and event collection in the gateway,
increasing data throughput when multiple master controllers are connected.
l
The PXL controller firmware revision was not being displayed in the grid.
l
Provided the ability to allow PXL masters to be placed in different world time
zones.
l
Optimized timing parameters in the gateway to improve data throughput.
l
Added a check on credential block enroll for quantity of more than 100 records and
automatic download is enabled on any PXL master. If those two conditions are
met, a message is displayed to the user with two options 1) either reduce the quant-
ity or 2) set the PXL to manual update. This check is necessary due to the slow
data transfer rate from master to slave units.
l
Changed the level of detail on certain Live Event messages to be less technical
and more user friendly.
l
Ensured that if a Smart Update was initiated on a master controller, any slave con-
trollers also requiring an update were updated as well.
l
Added the ability to select if an Update Network or Smart Update command
applies to the master only or to the master and slaves.
l
Added a check to Holiday scheduling to ensure only a holiday type of 1, 2, or 3 is
selected. The PXL cannot support greater than 3 holiday types.
Unique to Keri NXT Mercury Powered Controllers and Mercury Hardware:
l
When adding controllers manually, the program's user interface now waits until a
controller update is complete before allowing the next controller to be added.
l
Added an automatic status update request following a firmware upgrade on RIMs
and 4x4s to collect the information needed to immediately update the unit's status
following the upgrade.
l
When manually adding Mercury Hardware, the software automatically adds a net-
work communication channel to support the hardware, instead of requiring the com-
munication channel to be added manually. Conversely, if you manually remove
hardware its communication channel is now automatically removed as well.
l
If a controller's Daylight Savings Time rules are changed, the controller is now
tagged as needing to be reset so the new DST rules can be applied to the con-
troller.
l
Controllers would not enforce DST rules following a reset as the information was
cleared. Controllers now retain this information regardless of the reset function.