Id - displays the camera provider id, Name - displays the camera name, Manufacturer - displays the camera manufacturer – Keri Systems Doors.NET Manual User Manual
Page 361: Camera type - displays the type of camera, Revision - displays the camera revision
![background image](/manuals/697241/361/background.png)
Doors.NET Reference Manual
- 361 -
l
Post-Alarm Buffer - set the number of seconds of post event video that should be
saved when an event-triggered video is recorded. The range is from 0 to 60
seconds. The default is 10 seconds.
l
Video CODEC - select the video CODEC to use for encoding/recording video. This
list will only include CODECs that are available to your PC's video system.
Buffer Settings
l
Size - set the video buffer length (the amount of video storage space, in minutes).
The range is from 0 to 30 minutes. A buffer size of 0 minutes means there will be
no video rewind as there would be no buffer into which video would have been
stored.
l
Quality - set the quality of the video stored in the buffer. Values range from record-
ing full-motion video to recording in "X" second intervals or in every "X" number of
frames.
l
Recording Type - set the recording type. The type can be video, a single snap
shot, or a burst of snap shots.
Provider Settings
l
Settings - allows you to set specific video operating parameters for the selected
camera. Default values are automatically entered. Expand the data tree to view/set
non-standard operating parameters.
l
Camera Number - set the camera number for the video source (1 to 4).
l
Frame Rate - set the frame rate. This is the number of frames to record per
second.
l
Resolution - set the frame resolution. This is pixel dimensions for the video
window.
l
Source Address - set the source address of the camera. This could be an IP
address, file name, or URL.
l
Stream Type - set the stream type to be displayed mpeg versus mjpeg. mpeg
provides better data compression, but may not provide a clear a picture as
mjpeg.
l
User Name - enter the user name set in the camera's driver.
l
User Password - enter the password set in the camera's driver.
l
ID - displays the camera provider ID.
l
Name - displays the camera name.
l
Manufacturer - displays the camera manufacturer.
l
Camera Type - displays the type of camera.
l
Revision - displays the camera revision.
l
Video Quality - set the video interpolation mode which determines how much video
quality should be retained to allow for resizing the video.