Keri Systems Doors.NET Manual - Manual (Page 396)

Doors.NET Reference Manual
- 396 -
8. Next step is to configure the controller. Advanced view must be enabled to see all
the relevant sections. Click on the desired controller in the Hardware tree and view
its properties.
9. The image above shows the Controller Function is set to Normal. Double-click in
this cell and change the selection to ‘Elevator Control.’ An alert appears asking
you to confirm the change. Click Yes and the function is then set. Click Save.
10. Further down the properties list is the Elevator Control settings. Select the 20-floor
Facility and set the Elevator Floors count to 20.