Keri Systems Doors.NET Manual - Manual (Page 558)

Doors.NET Reference Manual
- 558 -
9. At this point you can test the functionality of the procedures by right-clicking and
selecting Execute.
10. After executing the first procedure you should see an event for the reader in live
events stating: 'Reader Mode Change - Card + Pin'.
11. Should you wish you could also present a valid card at the reader and you will
notice that access will not be granted until a PIN has also been entered.
12. When you execute the second procedure you will see the event: Reader Mode
Change - Lock. Again you can the mode test with a valid card read - verifying that
only a card read is required to gain access.
Trigger Setup
Two triggers must now be defined. The first trigger will be the input going active and will
activate the Card + Pin procedure. The second trigger will be the input going back to
secure and it will activate the Card OR PIN procedure.