Keri Systems Doors.NET Manual - Manual (Page 406)

Doors.NET Reference Manual
- 406 -
Filters
Filters are used by the system to specify which system generated messages are dis-
played in the software as live event transactions. Any events which are not selected in
the filter will not be displayed in the administrative client.
The system has 4 different filter types defined: Access Denied (the most common access
denied messages), Access Granted (the most common access granted messages), Con-
cise setting (defaulted to the minimum display of event transactions, which is basically;
alarms, troubles, and access granted messages and the standard setting is defaulted to
a few more events that concise.
All the events assigned to these filters are listed with a checkbox, all of these filter types
can also be changed and altered at any time, or you can of course create your own fil-
ters.
None of these filters are assigned to any of the hardware, by default, meaning all the
events generated by the system will appear in the user client in Live Events. However
note that these filters ONLY affect the display of the event only as all events are recorded
to the hard disk in the messages table.
Setup a Filter
This filter example will be setup and assigned to a reader connected to an NXT-MSC
controller.
1. Click Setup >> Filters (if the Filter icon is not displayed you will need to enabled
Advanced View ).
2. With the filter highlighted, type in a new description in the description field then
click the blue save/save all icon.