Keri Systems Doors.NET Manual - Manual (Page 398)

Doors.NET Reference Manual
- 398 -
Adding a 4x4 Adding a GIOX Unit
16. Check the 4x4 or GIOX outputs are configured correctly by highlighting one of the
outputs listed on either the 4x4 or the GIOX. The output properties should show
them as set to ‘Elevator Output.’
17. Now highlight the reader located on bus 1. Reference the properties and look for
the Master/Slave (In/Out) settings. The reader will be automatically set to ‘Elevator,
No Floor Select’ or you can change it to ‘Elevator, With Floor Select.’