Keri Systems Doors.NET Manual - Manual (Page 42)

Doors.NET Reference Manual
- 42 -
feature addition, requiring the user to repeat the activation process when Internet
access is finally restored.
l
Added a notification for the user such that if a Gateway is offline when a Syn-
chronize Clocks command is performed a notification dialog appears to alert the
user that the Gateway could not be synchronized.
l
Added an automatic Gateway assignment such that when a new Gateway is
added in the Gateway Wizard, that new Gateway is automatically selected before
continuing to the activation step. Previously you had to manually select the newly
created Gateway.
l
Added cut-and-paste capability when entering a starting IP address during auto-
configuration. The address field will parse the data being entered and delete it out
if invalid characters are entered.
l
Disabled the Apply button during an auto-configuration. The Apply button has no
purpose during the auto-configuration process, so it is now disabled (grayed out)
during auto-configuration to minimize confusion during the auto-configuration pro-
cess.
l
Corrected the status update process following an auto-configuration to only collect
status on the selected controllers. This speeds up the status collection time and
does not collect unneeded data.
l
Corrected an auto-configuration issue with very old NXT firmware revisions
(2.03.12 or earlier) where the software is waiting for a specific response from the
firmware that early firmware revisions do not provide.
l
Added a notification regarding the proper method to change a controller's IP
address. A user cannot change a controller's IP address from the Communication
Setting property, it must be changed during auto-configuration.
l
Increased the time out values used for firmware updates to accommodate updating
via slow, wireless networks.
l
Implements an Update Network Required notification to be displayed in multiple
places when applicable. Certain types of system changes are not automatically
updated on the network. These notifications alert the Operator to the need to per-
form a manual update when ever necessary.
l
Corrected a settings issue with keypad readers where if you changed to a non-
standard setting the keypad reader would work correctly, but if you made a sub-
sequent change to any other reader value, the keypad reader would revert to
default settings.
l
Corrected a display issue under Access Groups where Keypad readers were listed
by code number and not manufacturer model.
l
Corrected an interface display issue where the correct state for disabled readers
was not displayed properly following an auto-configuration until the user client was
restarted.
l
Corrected a Controller status issue that prevented the Reader status from being
properly displayed under certain conditions.