Keri Systems Doors.NET Manual - Manual (Page 403)

Doors.NET Reference Manual
- 403 -
14. The last step is to open up a card record (which has an active card enrolled). Click
on the Access Rights tab and select the newly created group. Then click Save.
15. Verify the elevator control configuration. Present the card to the elevator cab
reader. You should get access granted, a green LED on the reader, and the first 12
relays should activate.
Either: all four relays on the NXT controller plus the eight outputs on the 4x4s
or the four relays on the NXT controller and all eight outputs on the first GIOX out-
put module.