Keri Systems Doors.NET Manual - Manual (Page 597)

Doors.NET Reference Manual
- 597 -
Advanced View
Advanced View is not enabled by default on a standard Doors.NET installation, even for
the default System Administrator. If you highlight a controller in the hardware tree and
can only see limited properties/settings then you will need to enable Advanced View.
System Operators can also be setup so that they will be prevented from enabling it.
If Advanced View is not enabled your controller properties will look similar to below:
1. In Doors.NET Click the View tab >> Advanced View.
2. In the Password field enter: Keri10 then click ok.