Keri Systems Doors.NET Manual - Manual (Page 51)

Doors.NET Reference Manual
- 51 -
Program Improvements:
l
Corrected typographical and display field errors in several program windows.
l
Corrected information field sizing issues that appear when using non-English lan-
guages.
l
Re-enabled sorting by Access Group for transaction reports. Please keep in mind
that cardholders who are assigned to multiple Access Groups may not sort as
expected.
l
Added a gateway identifier to the Access Group assignment screen to eliminate
confusion on gateway assignments. If an operator had assigned identical names to
controllers on different gateways it could be difficult to assign the desired Access
Group to the correct controller/gateway combination. To correct this a gateway iden-
tifier has been added to the controller information displayed on the Access Group
screen.
l
Now automatically divides event history archives into manageable sized files.
Adds the ability to selectively search through and report on event transactions by
archive. Reports are presented on a per archive basis and cannot span multiple
archives. These changes increase the speed of sorting and searching. All sorting
is now done on the event history grid.
l
Corrected the reporting of RIM and 4x4 firmware revisions in the individual device
listings in the hardware tree following an Auto-Configuration. The firmware revision
for these devices would be listed in the controller tree, but no value would be
shown under the individual device trees.
l
Improved the Temporary Cardholder time resolution to correctly handle short-term
credentials (i.e. the credential has a short activation period and it becomes active
in a short amount of time).
l
Corrected a speed-of-processing issue when multiple, single-card presentation
enrollments are done back-to-back. Some cards may have been dropped from the
enrollment process.
l
Corrected a speed-of-processing issue when multiple controllers are added manu-
ally. If the controller additions were made too quickly the hardware trees displaying
the individual controller peripherals (such as readers) would not be filled correctly.
l
Corrected an issue with displaying reader names when using a 4x4 to handle door
strikes for a controller. A hard-to-interpret ID number was displayed rather than the
reader name assigned to the door strike.
l
Corrected an issue when assigning door contacts on a 4x4 relay board. The
assignments on the 4x4 would not be completely implemented until the operator
also saved corresponding changes on the corresponding reader. The program
now prompts the operator to save all changes.
l
Corrected an issue when an installer removes a 4x4 module from an installation;
the program would remove the 4x4 without checking if any programmed inputs
were assigned to that 4x4. The program now checks for 4x4 programming and