Adept Python - Manual (Page 90)

Chapter 5 - Module System Descriptions
90 Adept Python Modules User’s Guide, Rev. E
5.5 Mounting Options
When a Python module system is configured, mounting feet or toe clamps can be
included. Mounting feet are aluminum plates that bolt to the underside of module 1 and
allow the fully-assembled system to be bolted in place. Toe clamps are inserted into the
T-slots on the sides of module 1 and secured to the mounting surface. Each toe clamp kit
contains four toe clamps and two mounting screws per toe clamp. The type and number
of mounting feet or toe clamps are automatically configured based on the selected stroke
length for module 1.
The two digits following the system orientation characters define both mounting feet/toe
clamps and the quantity of feet/toe clamps required. In the example from
Figure 5-1 on
page 68 , “13” indicates an L18 module configured with three mounting feet. The
following chart shows all the available mounting options and the descriptor numbers
used to indicate them.
Figure 5-27. Mounting Options in Module System Descriptor Number
NOTE: If a gantry support module is included in the system, and if
mounting feet or toe clamps are configured on module 1, the same
number of gantry mounting feet/toe clamps are automatically included.
If no mounting feet/toe clamps are specified on module 1, no mounting
feet/toe clamps are configured on the gantry.
00
MOUNTING OPTIONS
L18 Mount Feet Kits, Quantity 2
00
12
13
21
15
22
23
25
33
32
No Mounting Hardware Supplied
L18 Mount Feet Kits, Quantity 3
L18 Mount Feet Kits, Quantity 5
L12 Mount Feet Kits, Quantity 1
L12 Mount Feet Kits, Quantity 2
L12 Mount Feet Kits, Quantity 3
L12 Mount Feet Kits, Quantity 5
L08 Mount Feet Kits, Quantity 2
L08 Mount Feet Kits, Quantity 3
81
1 Toe Clamp Kit, Quantity 4 Toe Clamps
82 2 Toe Clamp Kits, Quantity 8 Toe Clamps
83 3 Toe Clamp Kits, Quantity 12 Toe Clamps