Daktronics AB-1600-1.5,2.5 - Manual (Page 8)

1-2 Introduction
All references to drawing numbers, appendices, figures or other manuals use in bold typeface, as
shown below.
“Refer to Drawing A-114667 in Section 3 for the location of the Venus 1500 controller.”
In addition, any drawings referenced within a particular sub-section are listed at the beginning of that
sub-section in the following manner:
Reference Drawing:
Shop Drawing, 16 High 2 ½ ˝ Small Matrix .......................................... Drawing A-114667
Appendix A contains all referenced drawings.
Daktronics identifies manuals by the ED number located on the cover page of each manual. For
example, Daktronics refers to this manual as ED11944.
Please list the model number, display serial number and the date this display became operational in the
blanks provided on the front page of this manual. The ID label, located on the front of the display on
the right end, contains the serial and model numbers. This label will look similar to the one shown in
Figure 2. When calling Daktronics Customer Service, please have this information available to ensure
that we service your request as quickly as possible.
Daktronics builds displays for long life and require little maintenance. However, from time to time,
certain display components will need replacing. The Replacement Parts List in Section 4.15
provides the names and part numbers of components that may need to be ordered during the life of this
display.
Following the Replacement Parts List in Section 4.15 is the Exchange/Replacement Procedure in
Section 4.16. Refer to these instructions if any display component needs repair or replacement.
Figure 1: Drawing Label
Figure 2: Display ID Label