OpenEye Gen6 X-Series - Manual (Page 101)

102
Using the Graphical PTZ Controller
1. In the Display screen, click Pan/Tilt .
2. Click the viewing area of the PTZ camera you want
to control.
3. Use the Arrow buttons to control the direction of the
PTZ camera.
4. To select a new camera, click the video display of a
different camera on the Display screen display.
Note Eight directions are available only for select
cameras. Only four of the PTZ Control buttons
work for all protocols (UP, DOWN, LEFT,
RIGHT).
Note The Advanced menu panel on the graphical
PTZ controller can be used to set PTZ preset
positions (on supported cameras), as well as
move to presets up to 254.
5. To exit the Graphical PTZ Controller, click Pan/Tilt
again.
Using the On-Screen Compass
1. On the Live screen, click Setup .
2. Click PTZ Setup .
3. Select the Camera Channel of the PTZ camera
you want to enable Onscreen Compass control
for.
4. In the General tab, select Onscreen Compass .
5. Click Apply .
6. Close the Setup window to return to the Live
screen.
7. Click Pan Tilt .
8. Control the PTZ camera by clicking and
dragging the mouse on the screen in the
desired direction.
Note A green line will appear to show the direction in which the PTZ camera will move. The shorter
the line, the less the PTZ will move. The longer the line, the more the PTZ will travel in the
specified direction.
Open & close
the Advanced
Controls panel
Current
camera
channel
Arrow buttons
Move to
preset
positions 1-10
Set presets,
and move to
presets 11-254
Open the
camera menu