Motion detection setup, Create a motion area – OpenEye Gen6 X-Series User Manual
Page 53
54
The recorder allows the user to adjust several different Motion Settings and create motion detection
areas.
Create a Motion Area
1.
On the Display screen, click
Setup
.
2.
Click
Motion Detection
.
3.
Select a camera from the
Select Channel
list.
4.
Select
Detect Detail Motion Area
.
5.
Click
Clear Motion Area
.
6.
Click
Setup Advanced Motion Area
.
7.
Click a
Motion Detection Area
shape button.
8.
Drag the mouse over the camera image.
Note
To create a polygon shape, click the mouse at each
point and double-click to close the shape.
9.
Click
OK
.
10.
Move the sliders to adjust motion sensitivity and the noise filter.
11.
Define the pre-alarm and post-alarm recording time for a motion event.
Pre Alarm Recording
– 0 - 120 Seconds [The number of seconds the recorder records before motion
is detected
—to ensure any motion occurring between I-frames is captured, set to a value greater than
0]
Post Alarm Recording
– 0 - 120 Seconds [The number of seconds the recorder records after it stops
detecting motion]
Clear motion area
Draw area
Selected camera
Camera toggle
Motion
Sensitivity
Noise Filter
Pre Alarm
recording
duration
Apply to all
Advanced
Post alarm
motion
duration
Post alarm
sensor
duratoin