OpenEye Gen6 X-Series - Manual (Page 98)

32539AF 99
The PTZ controls within the recorder allow you to control PTZ cameras without accessing them directly.
This can increase the usefulness of your recorded video. Using the PTZ controls, you can create
custom preset configurations that can continuously sweep across large areas.
Note These instructions are for use with
Analog PTZ cameras only. For IP
PTZ cameras, please refer to the
PTZ Camera Setup section of this
manual.
Note PTZ setup and control is only
available for supported video
encoders with a PTZ RS-485 pass-
through.
Basic PTZ Configuration
1. On the Live screen, click Setup , and
then click PTZ Setup .
2. Select a PTZ-enabled camera from the Select Channel list.
3. Select Enable Pan Tilt Connection .
4. Click Select Protocol and select the appropriate protocol for your PTZ camera. For information on
the protocol used by your PTZ camera, refer to your camera manual.
5. Set the appropriate Port , Baud Rate , Parity , Data Bits , and Stop Bits . These settings must match
those of your PTZ camera. For more information, refer to your camera manual.
6. Click Apply to save your settings.