Advanced ptz setup, General, Ptz address settings – OpenEye Gen6 X-Series User Manual
Page 99
100
General
The General tab in PTZ Setup allows you to reverse PTZ direction function if necessary, enable the use
of Onscreen Compass for PTZ control, set the speed for your camera, and set the camera ID.
Some protocols support software address settings.
The RX-Addresses and ID settings are compatible with a particular line of receivers that support 2 ID
addresses.
The PT Driver Address is associated with the PTZ ID address set on the camera. The addresses must
match for the recorder to communicate with the proper PTZ camera. This is especially important when a
large number of PTZ cameras are connected to the recorder.
Note
To select a PT Driver Address of 129-256, manually enter the ID in the box.
Adjust Speed
Settings
Reverse PTZ
controls
PTZ status when closing
PTZ controls on recorder
Enable Onscreen
Compass
PTZ Address
Settings