Ptz camera setup, Enabling an analog ptz camera, Enabling an ip ptz camera – OpenEye Gen6 X-Series User Manual
Page 51
52
PTZ cameras can be configured and controlled using the OpenEye recorder software. For instructions
on configuring and installing your PTZ camera, refer to the camera manual.
Enabling an Analog PTZ Camera
1.
Ensure that you have properly connected your analog PTZ camera to the recorder.
2.
On the Display screen, click
Setup
.
3.
Click
Camera Setup,
and then click
PTZ Setup.
4.
Click
Select Channel
, and then click the analog channel you want to enable as a PTZ camera.
5.
Select
Enable Pan Tilt Connection
.
6.
Type the appropriate
Protocol
,
Port
,
Baud Rate
,
Parity
,
Data Bits
and
Stop Bits
for your analog
PTZ camera. These must be the same settings that have been configured on the camera itself.
7.
Set the appropriate
General
and
Preset/Tours
options.
8.
Click
Apply
to save your settings.
Enabling an IP PTZ Camera
1.
Ensure that you have properly connected your IP PTZ camera to the network.
2.
On the Display screen, click
Setup
.
3.
Click
IP Cameras
, and then click the
Advanced Camera Setup
tab.
4.
Select the IP camera from the
Network Cameras Currently in Use
list.
5.
Select
PTZ Camera
.
6.
Click
Apply
to save your settings.