OpenEye Gen6 X-Series - Manual (Page 69)

70
Alarm Options
Use the Alarm Options section to configure the alarm output for specific events.
There are two Alarm Options:

Sensor Event – Trigger an alarm output based on a sensor

Motion Event – Trigger an alarm output based on motion detection
Motion can be designated as an alarm event. Often motion does not need to be treated as an Alarm
event. For example, during work hours, motion that occurs is expected and should not be treated as an
alarm. However, after business hours, any motion that occurs could be treated as an alarm.
1. In the Display screen, click Setup .
2. Click Recording Schedule .
3. In the Alarm Options section, select Sensor Event , Motion Event , or both.
4. Once you have selected an Event option, you can select alarm options.

Map Alarm – This enables the Alarm to activate the Map Alarm function on RADIUS
monitoring software.

Emergency Alarm – Send video to a PC running Emergency Agent software.
5. Set the Transmission Duration (in seconds) for this alarm.
6. Enter up to five Emergency IP of PCs running Emergency Agent software.
7. Select the appropriate Emergency IP addresses. You can only use one IP address at a time.
8. Click Apply to save your settings.
Tip See the Emergency Agent chapter for detailed information on setting up the Emergency
Agent software.