Storage management, Status check / email, General – OpenEye Gen6 X-Series User Manual
Page 74: Users
32539AF
75
Status Check / Email
Use the Status Check/Email tab in Storage Management to configure settings for status checks and
email recipients when status checks require attention. This function can keep you apprised of events
detected by your system without requiring you to check the recorder each day.
1.
On the Display screen, click
Setup
.
2.
Click
Storage Management
.
3.
Click the
Status Check/Email
tab.
4.
Click the
General
tab.
5.
Select
Enable Email Alarm
.
6.
Enter a
From Name
and email
Address
.
Note
This name and address will appear in the
From
line of
email alert messages.
7.
Enter the SMTP information for the email account that will
be used to send emails from the recorder. Contact your
administrator for this information if necessary.
8.
If using a secondary email account select
Use Secondary
SMTP
and complete the SMTP information.
9.
Click
Test
to send a test message to either address.
10.
Click
Apply
to save your settings.
1.
On the Display screen, click
Setup
.
2.
Click
Storage Management
.
3.
Click the
Status Check/Email
tab.
4.
Click the
Users
tab.
5.
Select the type of
Event
to send email on.
6.
Enter the
User
and
E-mail Address
of a desired recipient.
Note
Users and emails can be removed from the Users list
by clicking
Delete.
7.
Click
Add
.
8.
Repeat for additional recipients and types of events.
Note
A separate email notification for each type of event
must be set up for a single recipient to receive
notifications for each type of event.
9.
Click
Apply
to save your settings.