OpenEye Gen6 X-Series - Manual (Page 61)

62
Use the Alarms/Sensor menu to configure your alarms, sensors, and relays. To access the
Alarms/Sensors Setup screen, click
Setup on the Live screen, and then click Alarms/Sensor .
Alarms
Intensive on Recording – Enable this function to increase
the frame rate and resolution for a camera if an alarm or
sensor is activated, or if motion is detected.
Video Loss Alarm – Determine how the recorder will
respond if a camera channel loses video. The recorder can
beep, the loss can be added to the System Log, or you can
activate an external alarm.
Login Failure – Enable this function for the recorder to
beep continuously in response to a failed login attempt.
Only an authorized login will stop the beeping.
Sensors
1. Double-click a Sensor Name , and then type an appropriate name for your alarm sensor.
2. Double-click Type , and then select the contact type for this alarm, Normally Open ( N0 ), or Normally
Closed ( NC ).
3. Double-click Relay , and type the time, in seconds, you want to elapse between the detection of the
sensor and when the alarm is activated.